User manual

27|Page
7. Default values – will perform basic factory reset.
After making any changes click on “save changes”.
3.2.3 Time Parameters
1. The maximum time of a call. This time can be prolonged during the call by using the
commands * or # (see page 24).
2. Number of rings of an incoming call. This can be preset to from 1 to 9 rings. Following
the first ring the LED will also start to flash on the front panel, after a set number of
rings the System will automatically picks up the call.
3. The maximum length of time between button presses [range 1-9 seconds]
 Switch on – if the length of time between two following buttons is longer than
the set time the code will not be evaluated correctly.
 Dialling – if the button pressed is the same as first character the password for
switch on, the option will be delayed for this length of time.
4. Length of time for which the System hangs up before picking up again for repeat
dialling (press of a button during call or dialling, busy tone [range 1-5 seconds]).
5. After finishing the dialling the System waits for a specified length of time before
another call can be made, if a call is attempted during this time the busy tone will be
heard [range 04-99 seconds]. Dialling is repeated if the System operates in the mode
2 groups of numbers.
6. Selection of whether you want an acoustic signal for pick up and hang up.
7. Selection of whether you want an acoustic signal for other commands.
8. Default values – will perform basic factory reset.
After making changes click on “save changes”.