Use and Care Manual

Algae Build Up
Keep in mind that algae grows more quickly in bright sunshine areas, so you may choose not to put
your fountain in direct sunlight. We highly recommend changing the water in the fountain every month to
reduce the growth of algae.
To help prevent the algae build up on your pump and fountain, we suggest using Alpine’s All Natural Fountain
Formula on a weekly basis. This formula will also ght against mineral deposits and remove these deposits.
Maintaining the pump will prevent water build up which can harm your pump.
Winter Fountain Care
In cold climates, Alpine highly recommends to store your fountain and pump inside during the coldest
months of the year. If this is not possible follow the steps below:
1. Unplug and drain your fountain completely until it is completely dry of water
2. Fill the fountain bowl(s) with burlap to prevent water from freezing on your fountain
3. Disconnect the pump from the tubing located on the back of the fountain
4. Store the pump inside during the winter to prevent water freezing inside the pump motor
5. Cover the fountain with an Alpine waterproof cover for the winter
The purpose of this process is to keep water from staying or building up in your water feature. The
water in your fountain could freeze and therefore expand, leading to aking surfaces or even cracks. Make
sure to check your fountain during the winter season often in order to prevent any water build up.
Protect Your Fountain: Exposure to sun, rain and snow can damage your fountain
All of Alpine’s fountains are coated with UV protection nish yet due to uncontrollable weather
conditions, we highly recommend recoating your fountain to lengthen the life of your fountain and prevent
the nish from fading and peeling. In order to protect your fountain from outdoor weather exposure, we
recommend you spray your fountain every 6-12 months using Alpine’s Americana Acrylic Sealer Finish.
1. Clean the entire fountain of all dust and debris using warm water
2. Let the fountain completely air dry
3. Shake the can of Alpine’s Americana Acrylic Sealer Finish thoroughly before applying
4. Hold the can approximately 10 inches away from the surface of the fountain and spray with a smooth
side-to-side motion
5. Allow at least 15 minutes for the coat to dry
6. Repeat steps 3 -5
7. For extra protection in water running areas, spray a third additional light coat
8. Allow sealant to dry for at least 24hrs before running your fountain again
For more information or for fountain care product details, please visit us on the web at www. Alpine4u.com or call
one of our highly trained Customer Service Specialists at 877-710-0162.