User's Manual

47-EN
Front Camera screen example
Side Camera screen example
4 Touch [ ], [ ], [ ] or [ ] to adjust the position of the
guide.
• Touching [Clear] clears adjustments and returns to the setting
before guide line alteration.
5 After the adjustment is completed, touch [Set].
Adjusting Guides Simultaneously (for Rear/Side Camera
only)
<Rear Camera>
1 Touch [Link].
The 3 vertical guides of the currently-selected guide link
together, allowing them to be adjusted simultaneously.
• Note on the yellow guide line “ ” in the center
The yellow guide line “ ” in the center is controlled by a system that
locates it in the center of the two yellow guide lines, “ ” and “ ”
on the left and right, or the green line “ ” on the top and red guide
line “ ” below. Therefore you cannot move it manually.
<Side Camera>
1 Touch [Link].
The 2 vertical guides of the currently-selected guide link
together, allowing them to be adjusted simultaneously.
Turning Guide Display On/Off (Rear/Front Camera only)
Turning the selected guide off.
1 Touch [On/Off].
The currently selected guide will turn off.
2 To turn the guide on, touch [On/Off] again.
• Guides that are turned off are still adjustable.
Returning Guides to Default
1 Touch [Default].
A message window will appear.
2 Touch [OK].
Adjusted values will return to default settings.
You can set whether to display the rear camera image when the gear
lever is moved to the reverse (R) position while the unit is turned off.
You can select this item only when Camera Select is “Rear.”
Setting item:
Camera Interrupt (Power Mode)
Setting contents:
On (Initial setting) / Off
When connecting the optional Multi Camera Interface box, you can
connect up to 3 cameras as Front Camera/Rear Camera/Side Camera.
Set to “On” ( ) to enable each camera.
Setting item:
Front Camera / Rear Camera / Side Camera
Setting contents:
Off (Initial setting) / On
Set to “On” and touch the camera name to make individual
adjustments.
Camera Interrupt Setting (Power OFF Mode)
(Rear Camera Only)
On: The rear camera image is displayed
Off: The rear camera image is not displayed
Setting Multi Camera to On/Off
Camera
Signal:
See “Setting the Camera Signal Input” (page @@)
Guide
Adjustment:
See “Setting the Camera Signal Input” (page @@)
Camera
Interrupt
(Power Mode):
See “Camera Interrupt Setting (Power OFF Mode)” (page
@@)