User's Manual
Table Of Contents
- Operating Instructions
- WARNING
- Features
- Getting Started
- Radio/RBDS
- Apple CarPlay (Optional)
- Auxiliary Device (Optional)
- Camera Operation (Optional)
- Setup
- Audio Setup
- Audio Setup Operation
- Adjusting Balance (Between Left and Right)
- Adjusting Fader (Between Front and Rear)
- Setting the Bass Level
- Setting the Treble Level
- Setting the Subwoofer
- Setting the Bass Engine SQ
- Setting the Volume for Each Application
- Setting the MX (Media Xpander)
- Equalizer Presets (EQ Presets)
- Setting Defeat
- Display Setup
- General Setup
- Application Setup
- iDataLink Operation
- Information
- Installation and Connections
- LIMITED WARRANTY
12-EN
Apple CarPlay is a smarter, safer way to use your iPhone in the car.
Apple CarPlay takes the things you want to do with your iPhone while
driving and puts them right on iLX-107. You can get directions, make
calls, send and receive messages, and listen to music, all in a way that
allows you to stay focused on the road. Just plug in or wirelessly
connect your iPhone via WLAN to iLX-107 and go.
• Before using this function, plug in your iPhone using Lighting to
USB Cable (Supplied with iPhone) and make USB connection or
wirelessly connect your iPhone via WLAN to iLX-107. For details,
refer to “Connecting your iPhone” (page 12).
• Some functions may not be available while driving.
About iPhone models usable with this unit
• The following devices have been tested and shown to work with this
unit. Correct function of earlier versions cannot be guaranteed.
iPhone SE: Ver.9.3
iPhone 6s Plus: Ver.9.1
iPhone 6s: Ver.9.1
iPhone 6 Plus: Ver.9.1
iPhone 6: Ver.9.1
iPhone 5s: Ver.9.1
iPhone 5c: Ver.9.1
iPhone 5: Ver.9.1
Connecting your iPhone
You can connect your iPhone to this unit via USB connection or WLAN
by your prefer.
By USB
Just plug in your iPhone using Lighting to USB Cable (Supplied with
iPhone) to iLX-107. If an iPhone has been connected to this unit via
WLAN, you should switch connection on Apple CarPlay Device list
screen.
By WLAN
Make sure to turn on WLAN on your iPhone and iLX-107. Also turn on
Bluetooth on your iPhone before making this connection.
1
Select the “Alpine iLX-107” from the Bluetooth
pairing list of your iPhone for pairing.
Make sure the unit is on Apple CarPlay devices screen for
paring.
2
Touch [pair] or [OK] after the same 6 character
Passkey appears on your iPhone and this unit.
3
If the connection was successful, the Apple CarPlay
screen is displayed.
• In order to use Apple CarPlay over WLAN, the vehicle’s Bluetooth
must be turned off. Please do not pair to the vehicle’s Bluetooth
connection to enable Apple CarPlay.
• You can also connect your iPhone from this unit. For details, refer to
“Registering the Apple CarPlay Device” (page 24).
• When you disconnect a registered iPhone from USB connection on
Apple CarPlay screen, it will change to WLAN connection
automatically.
Access to Apple CarPlay
1
Press the Home button.
The Home screen is displayed.
2
Touch [Apple CarPlay].
The Apple CarPlay mode is activated.
Touch the desired App icon on iLX-107, or use Siri function
by pressing Siri button.
When an iPhone 5 or later is reconnected to this unit during
Radio, setup screen, etc., a message-“Apple CarPlay
Connected” may be displayed on the top of screen for a
short while. Touch the message to change to Apple CarPlay
mode.
• The App must be Apple CarPlay compatible in order to appear in the
Home screen.
Apple CarPlay
(Optional)