Installation Guide

TROUBLESHOOTING
Dryer does not turn on
1. Check power to the unit and connections. Verify dryer is receiving the correct voltage
at the Terminal Block (check dryer label on the outside bottom of the cover).
2. Adjust the sensor range (refer to wiring diagram sheet).
3. Check for loose, disconnected or improper wiring. Especially make sure that the
sensor wires are well connected (refer to wiring diagram sheet).
If you did the 3 steps above and the dryer is still not working, place your hands
under the sensor and check for the following:
4. If the blue LED light turns on then the Main Circuit Board needs to be changed .
5. If the blue LED light does not turn on the Sensor and Program Board needs to be
changed, if after changing it is still not working the Main Circuit Board needs to be
changed.
6. If after the above steps it is still not working the motor needs to be changed.
Dryer does not shut off
1. It may be mounted too close to a counter or object and has gone into lockout. If
relocating appliance is not possible, adjust the range of the Sensor. Turn off power to
dryer then turn the range adjustment on the program board counterclockwise
towards low to decrease Sensor range (refer to wiring diagram sheet).
2. Check for loose, disconnected or improper wiring at Control Assembly (refer to wiring
diagram sheet).
3. Replace Sensor and Program board.
Dryer does not always turn on, or turns on by itself
1. It may be mounted too close to a counter or object and has gone into lockout. If
relocating appliance is not possible, adjust the range of the Sensor. Turn off power to
dryer then turn the range adjustment on the program board counterclockwise
towards low to decrease Sensor range (refer to wiring diagram sheet).
2. Check for foreign material on Optical Sensor next to Air Outlet.
3. Check for loose, disconnected or improper wiring at Control Assembly (refer to wiring
diagram sheet).
4. Replace Sensor and Program board.
Dryer blows only cold air
1. Check heat setting on control (if supplied).
2. Check for loose connections to Heating Element (refer to wiring diagram sheet).
3. Replace Heating Element
Dryer has loss of air volume
1. Check motor speed setting on control (if supplied).
2. Check for slow running Motor or burning smell. If so, replace Motor.
3. Check for lint buildup at the filter or air inlet holes. If so replace filter and clean air
inlet holes.