Installation Guide

Open cover and take hand dryer from wall
Replace cover fix brackets
Replace Sensor, Program board
1. Remove and retain 2 side security hex cover screws by allen key then move the cover.
2. It is recommended to take hand dryer from wall ONLY when replace a new motor or two side cover fix
brackets . Loose 4 base fix screw then take hand dryer from wall.
1. Remove grounding wire fixed on bracket by loosening screw(Be sure not to lose it and two gasket).
2. Loose two bracket fix screw from hand dryer base back.
3. Replace new bracket and please do not over tight.
4. Fasten grounding wire to bracket tightly and keep it as Base-->Gasket-->Wire-->Spring Gasket-->Bolt
1. Remove nozzle by loosening the nozzle screw (be sure not to lose it).
2. Remove sensor from its house and disconnect it from program board and main board. The melt adhesive
is only for safe transportation and no need to use it when replaces a new sensor.
3. Remove program board by loosening the two screws.
4. Connect new program board.
5. Connect sensor. Please take care not hurt the sensor board when replace a new one.
Allen key
Bracket
Bolt
Spring
gasket
Gasket
Hand dryer
base
Grounding wire
Bracket
fix screw
Base fix screw
Sensor
Sensor
house
House
cover
Sensor
Melt
adhesive
Nozzle
Program
board