Installation Guide

Table Of Contents

1. Disconnect motor wire from motor to Main Board.

2. Move air inlet right cover by loosening 4 screw(Be sure not to lose them).

3. Move motor ﬁx bracket and motor ﬁx rubber ring by loosening 4 screw(Be sure not to lose them).

4. Pull out motor lightly and disconnect two wire. Be sure two wire goes through motor house hole smooth.

5. Replace a new motor and keep it well installed. It is important to install the two rubber ring evenly.

6. It is recommended to weld the wire on motor‘s two connection pin.

7. Pull the two wire from the motor house lightly.

8. Reconnect motor wire as diagram.

If it is a normal air ﬁlter:

Just pull it out as it is soft. Then replace a new one.

If it is a HEPA air ﬁlter:

1. Remove air inlet right cover by loosening 4 screw(Be sure not to lose them).

2. Replace a new HEPA.

3. Replace over and do not over tight it.

Replace filter or HEPA filter (If supplied)

Replace motor

HEPA

Motor

Motor fix rubber ring

Motor fix bracket