Installation Guide

HEMLOCK
INSTALLING THE HAND DRYER UNIT
CAUTION: Make sure that no electrical wiring or pipe work are located directly behind
area of drilling.
1. If hardwired, disconnect power source of electricity previously bought to the hand
dryer location.
2. Be sure there is no obstruction between floor and dryer. If mounted over counter top
place dryer no less than 16 inches above counter. Do not install dryer over wash
basin.
3. Mark wall at appropriate mounting height according to height guide below.
Recommended Height Guide
From floor to bottom of dryer
Men 45”- 114 cm
Women 43”- 109 cm
Teens 42”- 107 cm
Young Children 34”- 86 cm
Handicapped 38”- 97 cm
4. Hold the template (supplied) against bare wall. Make sure that the line of template
Representing bottom of dryer is horizontal. Mark location of screws.
5. Remove shipping security screw located at center top of back-plate.
6. Use wretch (supplied) to remove the two mounting screws located at the side of the
cover and lift cover up from base plate.
7. If electrical wiring entry is made from rear, remove the pre-formed knock-out from
the base plate.
8. Attach base plate to the wall at the 4 previously marked points. Beware if you prefer
unit not to meet wall use rubber gaskets supplied.
9. Attach cover to the base plate. Push bottom in first.
10. Replace screws previously removed from cover using wrench.
11. Restore power and test for proper operation.