MODEL NO.
Introduction Thank you for purchasing Alpine Industries’ Willow Hand Dryer. This high-velocity hand dryer is extremely compact and dries hands in seconds. It was specifically designed and built for use in industrial settings and commercial offices. An onboard infrared sensor detects hands and automatically turns the dryer on. The Willow Hand Dryer also incorporates a replaceable, High Efficiency Particulate Air (HEPA) filter.
Specifications (cont.) Weight: 9.5 lbs Product Type: High Speed Sensor Activated Material: 304 Stainless Steel Dry Time: – 8 sec. Decibel Rating: 80dB Blower Rotation Rate: – 25,000rpm Air Speed: *100-200 mph Size: 12-5/16” x 11-13/32” x 6-11/16” Parts List 1– 4– 4– 4– 1– Dryer Wall Screws Anchor Plugs Bushings Installation Template Note: Typical metal screws have been provided with this product. These may be used in conjunction with the anchors for most types of wall/wall studs.
Components List 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. Cover Hex Screws Base Plate Blower Motor Speed Adjuster LED IR Sensor Knock Out Plate HEPA Filter Cover Tabs Filter Tabs Blower Outlet Mount Holes Slot www.AlpineIndustries.
BEFORE INSTALLATION Caution: Make sure that no electrical wiring or pipe runs are located in the wall cavity behind where this dryer is to be installed. If installing with the hard-wire option, de-energize all electrical lines before installation begins. Hard-wire installation should only be attempted by a licensed electrician. 1. Remove all packing material (recycling is recommended) 2. Carefully remove the hand dryer from the shipping carton. 3.
INSTALLATION (cont.) 9. Attach base plate to the wall at the 4 points previously marked using the installation map. 10. Attach cover to the base plate (push bottom in first) and replace screws previously removed from cover using hex wrench. 11. Restore power and test for proper operation. WIRING DIAGRAM www.AlpineIndustries.
BACK PLATE DIMENSIONS www.AlpineIndustries.
BACK PLATE DIMENSIONS (cont.) www.AlpineIndustries.
Maintaining the Dryer Filter Examining and changing a HEPA filter regularly keeps hand dryers working efficiently. The service life of your HEPA filter depends on the frequency of use and the environment your hand dryer is in. High traffic/high usage/ environments high in dust or debris will need more frequent inspection and replacement of the HEPA filter. The HEPA filter should be inspected at least 4 times per year in a moderately trafficked, normal washroom environment.
Trouble Shooting The procedures in these instructions are intended for use only by a certified electrician. Lay persons should not attempt to trouble shoot the dryer and should contact their local electric service technician. Dryer does not turn on 1.Check power to the unit and connections. Verify if dryer is receiving the correct voltage at the Terminal Block. 2. Check for loose, disconnected or improper wiring. Ensure sensor wires are all well connected (refer to diagram sheet).
Limited Warranty BEFORE REQUESTING SERVICE, PLEASE REVIEW THE TROUBLESHOOTING GUIDE TERMS AND CONDITIONS OF ALPINE’S WILLOW HAND DRYER 5 YEAR LIMITED WARRANTY Your warranty begins at the date of purchase. Please retain your proof of purchase. If you do not have your proof of purchase, the warranty begins 30 days after the date of manufacture according to Alpine’s records. The warranty coverage only covers the original owner of the dryer.
