Use and Care Manual

Introduction
Thank you for purchasing Alpine Industries’ Willow Hand Dryer. This high-velocity hand
dryer is extremely compact and dries hands in seconds. It was specifically designed and
built for use in industrial settings and commercial offices.
An onboard infrared sensor detects hands and automatically turns the dryer on. The
Willow Hand Dryer also incorporates a replaceable, High Efficiency Particulate Air (HEPA)
filter.
Features
Touch Free Operation
8 Second Approximate Drying Time
HEPA Filter reduces contaminates from entering the air during use
Quiet operation – ideal for sound-sensitive areas
Equipped with Air Speed Adjustment
Durable, vandal resistant stainless steel cover
Simple mounting for easy installation
Conventional wall plug and hard-wire options
Warning
This manual must be read carefully before attempting to install your Willow Hand Dryer.
Not following safety rules or instructions outlined in this manual can cause the hand
dryer unit to not operate properly and could result in property damage, serious bodily
injury and/or death. Alpine Industries will not be liable for any damages caused by fail-
ure to comply with the installation and operating instructions outlined in this manual or
damages caused by improper use. Improper use or failure to comply with installation
and operating instructions voids the warranty on this h and dryer. Never remove the unit
cover unless electricity is turned off. Make sure both air inlet and exit grills are always
kept free of obstruction to ensure proper air flow. If you have any questions regarding
the installation or operation of this hand dryer, please contain an Alpine representative.
Specifications
120V Version
High Point = 120/ 1400W/11A
Low Point – 120V/ 470W/3.9A
High Point: Motor=600W, Heat Element=800W
Low Point: Motor=230W, Heat Element=240W
220V Version
High Point=220V/ 1400W/6A
Low Point=220V/ 320W/1.4A
High Point: Motor=600W, Heat Element=800W
Low Point: Motor=230W, Heat Element=240W