Installation Guide

RECOMMENDED BLOCKING:
OPERATION:
USE OF RESTRAINT SYSTEM:
Using Backer Plate Mounting System:
MAINTENANCE AND CLEANING:
If the walls do not have studs on center, then additional
blocking is necessary (Fig. E).
Contact an architect or building contractor to make sure the
blocking is adequate and complies with building codes.
Rotate base downward. Place infant on top of the changing surface.
Use restraint system as described below. After child has been changed,
remove restraint system and rotate base back up against the wall.
Place child so restraint strap is located at abdomen. Rotate top of buckle upward and insert
strap in buckle. Pull strap through buckle until snug against infant. Rotate top of buckle
downward to lock the strap into place. Slide yellow locking tab over top of buckle (Fig. F).
Reverse steps to loosen strap.
If your changing station was supplied with a backer plate, please follow these instructions. If a backer plate was not supplied and you
would like to order one, see information on page 1.
The backer plate is designed to enhance the attachment method to ensure that at least one wood stud is used to support the changing
station.
Clean by using a damp cloth with mild soap or mild multi-purpose cleaner. Do not use
any strong chemical cleaners or cleaning agents that may be hazardous to children.
Check all hardware and components monthly or as required to ensure hardware is tight and there
are no missing or damaged components. Take unit out of service if any component is missing or
damaged and contact customer service to order replacement parts. Do not substitute parts. For
replacement parts, contact customer service at [e-mail]
1. Locate wood stud where left side of changing station will be mounted to the wall.
2. Measure up 42" (107cm) from the floor and mark the wall.
NOTE: Mark on wall MUST be in center of wood stud.
3. Using two (2) 3" wood screws and a level, mount the backer plate to the center of the wood stud (Fig. G).
NOTE: The lip of the backer plate MUST be facing away from the wall (Fig. H).
Repeat steps to secure backer plate to another stud on the opposite side.
4. Slide recessed area on back of changing station onto lip of backer plate.
5. Return to installation step 5.
Fig. F
Locking
Tab
Top Of
Buckle
WARNING
WARNING
Child should never be left unattended.
Always use restraint system to avoid serious injury from fall or sliding out.
Weight limit 50 pounds (22.7 kg). Avoid adding parcels/packages/ accessories to the unit or the bag hooks that exceed the
weight limit. May cause unit to become unstable or hazardous conditions to occur.
Use backer place mounting system with at least four (4) standard mounting screws. The backer plate alone is NOT a
secure attachment method.
•
•
•
•
Fig. G
Fig. H
Side view of
Backer Plate
(10 1/4'')
260mm
For A.D.A.
Compliance
43 1/4"
(110cm)
31 1/2'')
800 mm
on center
Fig. E