Use and Care Manual

Automatic Hands Free Soap Dispenser
421-GRY, 421-WHI, 422-GRY, 422-WHI
User’s Instructions:
1. Place your hand below the dispenser spout within the sensing range. The dispenser will automatically release the preset amount of liquid or foam soap from the
nozzle spout.
2. Obtain additional soap by withdrawing hand and then again placing your hand below the
dispenser spout within the sensing range.
Installation
1. Please choose a vertical, clean and smooth mounting surface.
2. Make sure there is enough room above dispenser to access cover lock key.
3. Ensure there are no obstructions till at least 5’’ (127mm) below unit in sensor zone.
4. Unlock the front cover and take out the soap tank (Fig. 1).
5. Use the back plate for the drill marks and mark the 5 drill locations (Fig. 2).
6. Drill 5 holes at marked locations and insert 5 plastic anchors into drilled holes (Fig. 3).
7. Insert 4 screws into the 4 corner plastic anchors and leave 1/8’’ space from the wall under head
for hanging dispenser (Fig. 4).
8. Hang the dispenser on the screws through the keyhole slots at back plate.
9. Insert anti theft screw (Fig. 5).
10. Insert batteries (Fig. 6)
11. Replace the soap tank and fill it up.
Figure 1 Figure 2 Figure 3
Figure 4 Figure 5 Figures 6