ASPEN SOAP DISPENSER MODELS 428-L-GRY 428-F-GRY OPERATION & INSTALLATION MANUAL W W W. A L P I N E I N D U S T R I E S .
INTRODUCTION Thank you for purchasing this Alpine Industries Dispenser! The automatic and manual models were specifically designed and built for use in industrial settings and commercial offices to provide years of reliable service. The automatic model is equipped with onboard sensors that detect hands and automatically provides a portioned amount of soap. WARNING This manual must be read carefully before attempting to install soap dispensers.
PARTS LIST 1 — Dispenser 4 — Wall Screws 4 — Anchor Plugs 2 — Keys Note: Typical wood screws have been included with this product. These screws can be used in most types of walls and studs. However, other screw types may be needed such as: for masonry walls with tiles — use a carbide—tip drill bit. DISPENSER KEY WALL SCREW ANCHOR www.alpineindustries.
COMPONENTS LIST 1. cover 2. power adapter plug 3. key button 4. sight glass 5. dispenser 6. reservoir 7. screw cap 8. pump 9. case tab 10. pump tab 11. single dose button 12. double dose button 13. LED 14. internal unit 15. battery compartment 16. holster 17. flange 18. sensor 19. on/off www.alpineindustries.
PREPARING THE DISPENSER 1. Carefully remove dispenser from shipping carton, remove packing material (recycling is recommended), and inspect unit for damage. 2. Check for missing of damaged parts. If parts are missing or damaged contact the retailer. 3. Open the dispenser by inserting key, pressing down on key button 3 and swinging cover 1 down. 4. Pull out RESEVOIR 6 (see page 5), remove CAP 7, and fill with liquid or foam soap. Close CAP 7 tightly. 5.
PUSH TAB www.alpineindustries.
INSTALLING DISPENSER CAUTION: Make sure that no electrical wiring or pipe runs are located in the wall cavity where the dispenser is to be installed. TOOLS NEEDED Phillips head screw driver Drill Drill bit Stud finder Pencil 1. Mount over a counter top no less than 16 inches (40cm) above counter. Do not install dispenser over electrical outlets. 2. Hold the holster 16 against bare wall and mark location of screws on the wall. 3.
MAINTAINING THE DISPENSER Always unplug or remove batteries before cleaning. Only use a damp rag to wipe down the exterior of the dispenser. Never submerge the unit. Use a dry cloth to wipe sensors. Be sure the dispenser nozzle is clear of any dried soap or other debris. Occasionally open the cover to check battery level, LED will continually blink when low. Replace liquid or foam soap whenever levels are not visible in the sight window.