Installation Guide

Sanitary Napkin Receptacle
Item# 451-WHI/451-BLA/451-PNK/451-PUR
Installation
1. Please choose a vertical, clean and smooth mounting surface.
2. Make sure there is enough room above dispenser to open the cover.
3. Open the top cover and use the back plate for the drill marks for the 2 top and 1 bottom drill
locations.
4. Drill 3 holes.
5. Insert 3 plastic anchors (not supplied) into drilled holes.
6. Mount sanitary napkin dispenser on bottom screw with washer.
7. Remove inner liner.
8. Fasten top screws with washers through the slots at back plate, and replace inner liner.