ASPEN SOAP DISPENSER MODELS 427-L-GRY 427-F-GRY OPERATION & INSTALLATION MANUAL W W W. A L P I N E I N D U S T R I E S .
INTRODUCTION Thank you for purchasing this Alpine Industries Dispenser! The automatic and manual models were specifically designed and built for use in industrial settings and commercial offices to provide years of reliable service. The automatic model is equipped with onboard sensors that detect hands and automatically provides a portioned amount of soap. WARNING This manual must be read carefully before attempting to install soap dispensers.
COMPONENTS LIST 1. Cover 2. Power adaptor plug * 3. Key button 4. Sight glass 5. Dispenser 6. Reservoir 7. Screw cap 8. Pump 9. Case tab 10. Pump tab 11. Single dose button * 12. Double dose button * 13. LED * 14. Internal unit * 15. Battery compartment * 16. Holster 17. Flange 18. Sensor * 19. On/off * *only on automatic dispenser model www.alpineindustries.
PREPARING THE DISPENSER 1. Carefully remove dispenser from shipping carton, remove packing material (recycling is recommended), and inspect unit for damage. 2. Check for missing of damaged parts. If parts are missing or damaged contact the retailer. 3. Open the dispenser by inserting key, pressing down on key button 3 and swinging cover 1 down. 4. Pull out RESEVOIR 6 (see page 5), remove CAP 7, and fill with liquid or foam soap. Close CAP 7 tightly. 5.
TOOLS NEEDED Phillips head screw driver Drill Drill bit Stud finder Pencil 1. Mount over a counter top no less than 16 inches (40cm) above counter. Do not install dispenser over electrical outlets. 2. Hold the holster 16 against bare wall and mark location of screws on the wall. 3. Drill out 4 holes and insert wall anchors, install holster 16 and insert screws (do not over tighten screws). 4. Return internal unit 14 into holster 16. 5. Return reservoir being sure pump tab 10 is inserted around flange 17. 6.
MAINTAINING THE DISPENSER Only use a damp rag to wipe down the exterior of the dispenser. Never submerge the unit. Be sure the dispenser nozzle is clear of any dried soap or other debris. Replace liquid or foam soap whenever levels are not visible in the sight window. LIMITED WARRANTY Terms and Conditions of the Alpine 1 Year Limited Warranty — Your warranty begins at the date the purchase, please retain your proof of purchase. The warranty coverage only covers the original owner.
