Product Manual

BEFORE INSTALLATION Caution:
Make sure that no electrical wiring or pipe runs are located in the wall cavity behind where
this dryer is to be installed. If installing with the hard-wire option, de-energize all electrical
lines before installation begins. Hard-wire installation should only be attempted by a
licensed electrician.
1. Remove all packing material (recycling is recommended)
2. Carefully remove the hand dryer from the shipping carton.
3. Inspect carefully for any damage that may have occurred during transit.
4. Check for any loose, missing or damaged parts. If the hand dryer is damaged or missing
parts contact the retailer.
TOOLS NEEDED: Phillips Head Screw Driver, Drill Bit, Stud Finder, Pencil
Installing Dryer
1. Select a dedicated circuit breaker for the dryer.
2. Select a wall location height from floor to bottom of dryer according to the recommen-
dations below: MEN – 45” (114 cm) WOMEN—43” (109cm) TEENAGER – 41” (104cm)
CHILDREN—35” (89cm) DISABLED – 37” (94cm)
3. Be sure there is no obstruction between floor and dryer. If mounted over counter top
place dryer no less than 16 inches above the counter. Do not install dryer over wash basin.
4. Mark wall at appropriate mounting height according to the height guide above.
5. Hold the template (supplied) against bare wall. Make sure that the line of template rep-
resenting bottom of dryer is horizontal. Mark location of screws.
6. Use hex wrench (supplied) against bare wall. Make sure that the line of template repre-
senting bottom of dryer is horizontal. Mark location of screws.
7. If electrical wiring entry is made from rear, remove the pre-formed knock-out from the
base plate. Be sure to match the brown (neutral), blue (power), and yellow (ground) wires
when connecting directly to a gang box.
8. Insert rubber bushings (supplied) into rear corners of back plate if desired to keep dryer
from contacting wall.
www.AlpineIndustries.com
WILLOW HAND DRYER 4