Installation Guide

          
              
          
             
STEP 1 STEP 2
STEP 4
STEP 3
STEP 5 STEP 6
Soap Dispenser
fix Tray from
this side
press the circle
button to take
out tray
Take out Tray
Installation
Bottle+Pump
Front Cover
Key
Tray
Screw M4x15
(4pcs)
Back holder
Nut M4
(4pcs)
Screw M4x15
(3pcs)
Nut M4
(3pcs)
Advertising photo
AD Board
(2pcs)
* Advertising photo size: 18x 18cm
Screw M4x15
(4pcs)
Nut M4
(4pcs)
Base Screw/Nut
Pole 1
Base
(after fix dispenser
use this screw to lock)
Pole 2
Pole 3
Screw M4x40
Open it with key,take out the
bottle and pump
Install the back holder
with dispenser
Put Advertising photo inside
of 2 pcs AD board
Install the AD Board
on dispenser
* fix 4 pcs C size batteries,
fill liquid and turn on the
switch. enjoy your health
hand sanitizing.
Install Back Holder
Install AD Board（If Needed）
Install Pole and Base
Enjoy hand sanitizing