Owner`s manual

This unit
Screws (M5 x 8)
(Included)
~~/ Bracket Keys
'" (Included)
~
This unit
3. Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
This unit
~D
~+R
Front Frame
Connect each input lead coming from an amplifier to
the corresponding output lead coming from the left
rear of the CDE·1 03BT. Connect all other leads of the
CDE-103BT according to details described
in the
CONNECTIONS section.
3 Slide the CDE-103BT into the dashboard until it
clicks. This ensures that the unit
is properly locked
and will not accidentally come out from the
dashboard. Install the detachable front panel.
Removal
1. Remove the detachable front panel.
2. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw
(*') already
attached to the vehicle's chassis.
• For the screw marked" *2 ", use an appropriate screw for the chosen
mounting location.
Dashboard
Mounting Sleeve
(Included)
Screw
Remove the mounting sleeve from the main unit (see
"Removal" on page 31).
Q~ D ... "".b1. F,o.1
V Panel
Caution
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation. you
might press too hard and warp the metal plate that holds it
in
place.
Pressure Plates*
Less than
35°
* If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
2
• The main unit must be mounted within 35 degrees of the horizontal
plane. back to front.
1
Installation
Hex Nut (M5)
Metal
Mounting
Strap
Ground Lead
Chassis
Secure the ground lead ~fthe unit to a clean metal spot using a screw
(*3) already attached to the vehicle's chassis.
Mounting the Microphone
For the sake of safety, mount the microphone in the following location.
• In a stable and secure location.
• In a location that does
not inhibit safely driving the vehicle.
• Mount the microphone in a location where the driver's voice can
easily be picked up.
Choose a location for the microphone that can easily pick up the driver's
voice. Requiring the driver to move towards the microphone for
audibility causes a distraction that could be dangerous.
31-EN