Operation Manual

14-EN
3 Press and hold ESC for at least 2 seconds to return to
normal mode.
Notes
• If no operation is performed for 15 seconds, the unit will return to
normal mode automatically.
• The function is inoperable when DEFEAT is set to ON.
You can change the Bass Frequency emphasis to create your own tonal
preference.
 Setting item: BASS
Setting the Bass Centre Frequency
1 Press BANDTA to select the desired bass centre
frequency.
80 Hz  100 Hz  200 Hz  60 Hz  80 Hz
Emphasises the displayed bass frequency ranges.
Setting the Bass Bandwidth
1 Press SOURCE to select the desired bass bandwidth.
Changes the boosted bass bandwidth to wide or narrow. A
wider setting will boost a wide range of frequencies above and
below the centre frequency. A narrower setting will boost only
frequencies near the centre frequency.
Setting the Bass Level
1 Turn the Rotary encoder to select the desired bass level
(-7~+7)
*
.
You can emphasise or weaken the bass level.
* The adjustment can also be made by pressing Rotary encoder.
Refer to “Adjusting Subwoofer Level/Bass Level/Treble Level/
Balance (Between Left and Right)/Fader (Between Front and
Rear)/Defeat” on page 13.
Note
• The bass level settings will be individually memorized for each source
(FM, MW (LW), CD, etc.) until the setting is changed. The bass
frequency and bass bandwidth settings adjusted for one source are
effective for all other sources (FM, MW (LW), CD, etc.).
You can change the Treble Frequency emphasis to create your own tonal
preference.
 Setting item: TREBLE
Setting the Treble Centre Frequency
1 Press BANDTA to select the desired treble centre
frequency.
10.0 kHz  12.5 kHz  15.0 kHz  17.5 kHz  10.0 kHz
Emphasises the displayed treble frequency ranges.
Setting the Treble Level
1 Turn the Rotary encoder to select the desired treble level
(-7~+7)
*
.
You can emphasise the treble level.
* The adjustment can also be made by pressing Rotary encoder.
Refer to “Adjusting Subwoofer Level/Bass Level/Treble Level/
Balance (Between Left and Right)/Fader (Between Front and
Rear)/Defeat” on page 13.
Note
• The treble level settings will be individually memorized for each source
(FM, MW (LW), CD, etc.) until the setting is changed. The Treble
frequency settings adjusted for one source are effective for all other
sources (FM, MW (LW), CD, etc.).
The High Pass Filter on this unit can be adjusted to suit your personal
taste.
 Setting item: HPF
1 Turn the Rotary encoder to select the desired HPF
frequency.
OFF  60 Hz  80 Hz  100 Hz
All frequencies above the selected cutoff are output.
Turning Loudness On/Off
Loudness introduces a special low-and high-frequency emphasis at low
listening levels. This compensates for the ear’s decreased sensitivity to
bass and treble sound.
1 Press and hold Rotary encoder (LOUD) for at least
2 seconds to activate or deactivate the loudness mode.
Note
• The function is inoperable when DEFEAT is set to ON.
Setting the Bass Control
Setting the Treble Control
(Narrow)
(Wide)
Adjusting the High Pass Filter