Operation Manual

28-EN
•Mechanism error.
1 Press the  button and eject the CD.
If not ejecting, consult your Alpine dealer.
2 When the error indication remains after ejecting, press the 
button again.
If the error indication still does not turn off after pressing the 
button for a few times, consult your Alpine dealer.
• When “ERROR” is displayed:
If the disc cannot be ejected by pressing , press the RESET switch
(Refer to “Initial System Start-Up” on page 6) and press  again.
If the disc still cannot be ejected, consult your Alpine dealer.
• A copy-protected WMA file was played back.
– You can only play back non-copy-protected files.
• A sampling rate/bit rate not supported by the unit is used.
– Use a sampling rate/bit rate that is supported by the unit.
• Abnormal current is run to the USB connector device (an error
message may be displayed if the USB device that is not compatible
with the unit is connected).
USB Memory is a malfunction or it is shorted.
– Connect another USB Memory.
• A USB device that is not supported by the unit is connected.
– Connect a USB device that is supported by the unit.
• A USB Memory is not connected.
– Make sure the USB Memory device is correctly connected and the
cable is not excessively bent.
• No song (file) is stored in the USB Memory.
– Connect the USB Memory device after storing songs (files).
• A sampling rate/bit rate not supported by the unit is used.
– Use a sampling rate/bit rate that is supported by the unit.
• A copy-protected WMA file was played back.
– You can only play back non-copy-protected files.
• Text information that is not recognizable by the unit has been input.
– Use a USB Memory device with input text information that is
supported by the unit.
• The iPhone/iPod is not connected.
– Make sure the iPhone/iPod is correctly connected (Refer to
“Connections” on page 32).
Make sure the cable is not bent excessively.
• There are no songs in the iPhone/iPod.
– Download songs to the iPhone/iPod and connect to this unit.
• Communication error
– Turn the ignition key off, and then set to ON again.
– Reset the iPod.
– Check the display by reconnecting between the iPhone/iPod and
this unit, using the iPhone/iPod cable.
• Caused by the iPhone/iPod Software Version not being compatible
with this unit.
– Update the iPhone/iPod Software Version to be compatible with
this unit.
• The iPhone/iPod is not verified.
– Reset the iPod.
– Try another iPhone/iPod, if available.
• Power surge error
Excessive voltage/current is supplied to the iPhone/iPod.
– Try another iPhone/iPod, if available.
• The BLUETOOTH device is not connected.
– Connect the BLUETOOTH device.
Indication for USB Memory
UNIT ERROR
NO DEVICE
Indication for iPod Mode
BLUETOOTH mode
NO SUPPORT