Owner`s manual

22-EN
CD Player Operation
Multi-Changer Selection
Alpine's Ai-NET system will support up to 6 CD
Changers. When operating two or more changers, the
KCA-400C (Multi-Changer Switching device) must be
used. If you use 1 Switching device, you can connect up
to 4 CD Changers. If you use 2 Switching devices, you
can connect up to 6 CD Changers. When using KCA-
410C (Versatile Link Terminal), you can connect two
changers and two external outputs (AUX).
1 Press the SOURCE button on the DVA-7996 to activate
the CD Changer mode.
Alternatively, press the SOURCE button on the Remote
Control (RUE-4190) to activate the CD Changer mode.
2 Press the BAND button on the DVA-7996 or the RUE-
4190 to activate the CD Changer Selection mode.
3 The CD Changer Selection mode remains active for 8
seconds after step 2 is performed. Press the BAND
button until the desired CD Changer indicator appears
on the display.
NOTE
If the selected CD Changer is not connected, the display will
show “NO CHGR .”
Alternatively press the BAND button on the Remote
Control until the desired changer indicator appears on
the display.
4 To operate the selected changer, see “CD Player
Operation” section.
NOTE
For further details about the external input (AUX) when using
KCA-410C, see “Setting the AUX Mode (V-Link)” on page 17.
SOURCE BAND