Owner's Manual
Table Of Contents
- Installation Manual
- Introduction
- Note
- To Ensure Safe Use, Always Follow These Precautions
- Tools Possibly Required (This Will Vary Depending On The Vehicle)
- Accessory List
- Factory Unit Disassembly Process (2007-2010 Only)
- Factory Unit Disassembly Process (2011-2018 Only)
- Glove Box Removal
- Removing B-Pillar Panel
- Removing Rear Right Side Panel
- Spare Tire and Wheel Removal
- Camera & Light Extension Cable Installation
- Bracket Installation
- Wiring Diagram: OEM Head Unit With SGS-CH01 (Sold Seperately)
- Wiring Diagram: OEM Head Unit With ALP-HRN-CAMCH (Sold Seperately)
- Wiring Diagram: Alpine Head Unit Using Direct Connection
- Wiring Diagram: Alpine Head Unit With SGS-CH01 (Sold Separately)
- Wiring Diagram: OEM Head Unit With SGS-CH01 & KCX-C2600B (Sold Separately)
- Wiring Diagram: OEM Head Unit With ALP-HRN-CAMCH & KCX-C2600B (Sold Separately)
- Troubleshooting
- Quick Installation Manual
Jeep Wrangler
HCE-RCAM-WRA 15/16
Wiring Diagram: OEM Head Unit With ALP-HRN-CAMCH & KCX-C2600B (Sold Separately)
Factory Head Unit
To Rear
Camera Input
KCX-C2600B
(Sold Separately)
Reverse Out (Orange/Black)
Reverse In
(Orange/White)
Accessory (Red)
Battery (Yellow)
Ground (Black)
1 2 3 4 5 6
1 - V. Out
2 - Other Camera
3 - Front Camera
4 - Rear Camera
5 - Switch
6 - Power Wires
Alpine Direct Front Camera
Toggle Switch
NOTE: The HCE-C1100 can NOT be plugged in directly. It must be used with the
Power & Video unit and plugged in with the RCA.
Power & Video
Unit
Camera Extension Cable
HCE-RCAM-WRA
NOTE: It is highly recommended to
use an Alpine direct connect camera
for the front camera. Any other camera
can not be guaranteed to work.
Ground (Black)
Accessory (Red)
To Factory
Camera Connector
NOTE:
The OEM radio will need to be
ashed by a Jeep dealer
to enable the rear camera
feature when using the
ALP-HRN-CAMCH
ALP-HRN-CAMCH