Owner's Manual
Table Of Contents
- Installation Manual
- Introduction
- Note
- To Ensure Safe Use, Always Follow These Precautions
- Tools Possibly Required (This Will Vary Depending On The Vehicle)
- Accessory List
- Factory Unit Disassembly Process (2007-2010 Only)
- Factory Unit Disassembly Process (2011-2018 Only)
- Glove Box Removal
- Removing B-Pillar Panel
- Removing Rear Right Side Panel
- Spare Tire and Wheel Removal
- Camera & Light Extension Cable Installation
- Bracket Installation
- Wiring Diagram: OEM Head Unit With SGS-CH01 (Sold Seperately)
- Wiring Diagram: OEM Head Unit With ALP-HRN-CAMCH (Sold Seperately)
- Wiring Diagram: Alpine Head Unit Using Direct Connection
- Wiring Diagram: Alpine Head Unit With SGS-CH01 (Sold Separately)
- Wiring Diagram: OEM Head Unit With SGS-CH01 & KCX-C2600B (Sold Separately)
- Wiring Diagram: OEM Head Unit With ALP-HRN-CAMCH & KCX-C2600B (Sold Separately)
- Troubleshooting
- Quick Installation Manual
Jeep Wrangler
HCE-RCAM-WRA 4/16
Factory Unit Disassembly Process (2007-2010 Only)
DISCONNECT THE BATTERY BEFORE
CONTINUING. FAILURE TO DO SO WILL
DISABLE MANY FEATURES.
1 Remove top by releasing 2 rear clips on the back of
the top panel and then pull panel forward.
3 Release 2 clips on the top of the bottom panel. This
will expose two 7mm screws. Remove using a 7mm
socket with ratchet & extension.
5 Extract (4) 7 mm screws and remove the factory
radio.
2 Release 2 clips on the top of the bottom panel. This
will expose two 7mm screws. Remove those.
4 Use panel removal tool to remove dash panel by
releasing 6 clips (3 per side)
Warning: Before you begin wiring, remove the ground wire from the negative
terminal of the battery. Failing to do so can lead to electric shock, injury or damage
to equipment.