Installation Manual

Spare Tire Camera & Light System for Jeep Wrangler
 9/14
- Connection Type C –
If connecting to all other HU, cut Camera & Light
T-Harness and manually connect to each wire
located on the passenger’s kick panel, then connect
6pin black connector to gray connector on the
Camera & Light Extension Cable. (See page 14 in
detail)
Connect ACC and GND properly according to the
wiring diagram in page 14. Fail to do so could
damage the product.
2 Route the wires:
A. Start from the head unit harness
B. Behind the glove box
C. Down the passenger kick panel
D. Door sill
E. Along the rear right side panel
F. Along the rear door handle cable
G. Secure to the factory cables.
OPTION 1:
H. Remove OEM grommet. Route the wire out
of an OEM grommet hole. Insert the camera
harness cable and the OEM third brake light cable
through the rubber grommet provided. Cut rubber
grommet by a razor blade if needed.
I. Press the grommet fi rmly into the hole.
Use silicone to fi ll up all gaps around the grommet
and cables to prevent water going into the rear
gate.
Failure to do so may cause moisture to go inside.
J. Along and through the centric hub.
Route the cable so it does not interfere with any
moving parts or safety equipment.
Spare Tire Camera and Light Installation
336034 HCE-TCAM1-WRA_IM_r5.indd 9336034 HCE-TCAM1-WRA_IM_r5.indd 9 7/20/16 4:02 PM7/20/16 4:02 PM