Owner's Manual
Table Of Contents
- Installation Manual
- Quick Reference Guide
- Owners Manual
- Table of Contents
- Parts & Controls
- Operating Instructions
- Demo Mode
- Features
- Getting Started
- Radio/RBDS
- Apple CarPlay (Optional)
- Auxiliary Device (Optional)
- Camera Operation (Optional)
- Setup
- Audio Setup
- Audio Setup Operation
- Adjusting Balance (Between Left and Right)
- Adjusting Fader (Between Front and Rear)
- Setting the Bass Level
- Setting the Treble Level
- Setting the Subwoofer
- Setting the Bass Engine SQ
- Setting the Volume for Each Application
- Setting the MX (Media Xpander)
- Equalizer Presets (EQ Presets)
- Setting Defeat
- Display Setup
- General Setup
- Application Setup
- Audio Setup
- Information
- Troubleshooting
- Messages
- Specs
- Installation and Connections
- Read Before Installation
- Warranty
Installation
Instructions
1
The factory dash panel needs
to
be trimmed
to
allow
the
new
i1
09-WRA bezel
to
fit into place.
Remove the highlighted area
by
cutting along
the
dashed line.
3
Use a cutting
tool
to trim the highlighted area
shown below.
5
Attach iDatalink Maestro
to
main harness.
2
Remove the vents from
the
radio section on the
OEM
dash panel
by
pressing
down
on the
lock
tab
and turning right.
Mount
vents on
to
the
i1
09-WRA
bezel.
Rear
view
4
Mount
the
microphone as illustrated and run the
cable
to
the
radio cavity.
)