Installation Manual

Jeep Wrangler

WRANGLER  10/16

Installation Instructions

2 Plug the OBDII connector on to the OBDII port

below the driver side dash and run the extension to

the radio cavity.

4 Mount the microphone as illustrated and run the

cable to the radio cavity. You will need to use a T20

Torx to remove the visor. For optimal performance

it should be mounted by the rear-view mirror as

illustrated.

6 Mount the i207-WRA head unit using the factory

7mm screws and return factory panels to their

corresponding place

VOICE

1 Attention: For 2011-2017 vehicles only. Insert the

push clips from the factory bracket. Install the rear

support bracket, using the (2) 7mm screws that

were removed from the factory bracket, to attach

head unit bracket in the same place.

3 Attach the side brackets using the provided 8mm

round head screws.

5 For 2011-2017 vehicles: For vehicles with uConnect

refer to page 11. For vehicles without uConnect run

the USB extension cable to the glove box, connect

the main harness, antenna, and other adapters

to the factory harnesses and secure them. Route

all cables through the lower opening of the rear

support bracket as shown below.

For 2007-2010 vehicles: Connect the main harness,

run the USB extension from the back of the head

unit to desired location, connect antenna, other

adapters, and secure them.