Installation Manual

Jeep Wrangler
WRANGLER  12/16
i207-WRA Wiring Diagram
To Vehicle Connectors
CAN I/F
GPS
USB
W.REMOTE POWER
SXM/DAB
PRE OUT
HDMI IN HDMI OUT
ANTENNA
iDatalink MAESTRO Module
18-pin Black
Connector
10-pin Black
Connector
3-pin Black
Connector
(Audio)
10-pin Green
Connector
(Vehicle signals)
3-pin Black
Connector
(Power)
4-pin Black
Connector
(Data)
Blue Power Antenna
Blue/White Amp Turn-on
Direct Camera Input
AUX Power
3-pin Black Connector
Connect to SXM adapter
Black - Ground
Yellow -12V+
Red - Acc 12V+
Direct Camera Adapter
iLX-207 Source Unit
To OBDII Connector
Power/Speaker
16-pin Green Connector
OEM Audio
20-pin Gray
Connector
Power Harness
HDMI Interface
6-pin White Connector
Front
Rear
Rear
Front
Front
Rear
Rear
Front
For factory amplied vehicles switch the
speaker connectors, front to rear and
rear to front.
AMPLIFIED VEHICLES
Failure to follow this procedure will
result in no audio from Navigation and
Bluetooth sources.
Rear View Camera
6-pin Black Connector
Main Harness
White/Gray Manual Transmission Reverse Input
For manual transmission vehicles ONLY. Connect the
White/Gray wire to the White/Gray wire located
on the passenger side kick panel.
Rear View Camera
WARNING!
The use of this connection
is intended for Alpine
HCE-TCAM1-WRA rear
view camera ONLY.
Microphone
WARNING!
MANUAL TRANSMISSION VEHICLES
Cut loop when connecting
KCX-630HD HDMI selector
interface.