Other Content

v. 020818
Dear Consumer,
Thank you for your interest in an Alpine Restyle In-Dash System. We want you to have a positive and enjoyable experience with the system. To
help you learn about this product, we prepared a list of Frequently Asked Questions (FAQs) to address common inquiries about product use and
installation. Please read the FAQs below and if you have further questions, we invite you to contact us:
Alpine Customer Support:
1-800-832-4101
Monday - Friday, 7 AM - 5 PM PST
Online Support Center:
supportalpineusa.custhelp.com
Owner’s Manuals:
alpine-usa.com/support
Product Compatibility for Alpine Restyle In-Dash Systems:
10-Inch Screen:
• X110-SLV: Chevy Silverado (2014-2018). If used with the factory Bose system, the KCX-BOSE-GM interface is needed (sold separately).
• X110-SRA: GMC Sierra (2014-2018). If used with the factory Bose system, the KCX-BOSE-GM interface is needed (sold separately).
9-Inch Screen
• i209-GM: Chevy Silverado (2014-2018), GMC Sierra (2014-2018)
• X209-WRA, X209-WRA-OR, i209-WRA: Jeep Wrangler (2011-Up)
• X009-WRA, X109-WRA, i109-WRA: Jeep Wrangler (2011-Up)
• X009-RAM: Ram Trucks (2013-Up, not compatible with 8.4-inch
factory screen)
• X009-TND: Toyota Tundra (2007-2013)
• X009-GM: Compatible with the following vehicles with Lower-
dash factory radios; not compatible with fleet models: Chevy
Silverado (2007-2013), Chevy Avalanche (2007-2013), Chevy
Suburban (2007-2014), Chevy Tahoe (2007-2014), GMC Sierra
(2007-2013), GMC Yukon/XL (2007-2014)
• X009-GM2: Compatible with the following vehicles with Upper-
dash factory radios: Chevy Silverado (2007-2013), GMC Sierra
(2007-2013)
• X009-FD1: Ford F-150 (2009-2014, compatible with Base model
2013-Up F-150 if the HVAC controls can be separated from the
dash panel; not compatible with 4.2-inch MyFord screen or 8-
inch MyFord Touch screen)
• X009-FD2: Ford F-150 (2013-2014, compatible with 4.2-inch
MyFord screen only).
• X009-U: For custom installation
8-Inch Screen
• X108U, X208U: For custom installation or use with vehicle-specific dash kits, visit alpine-usa.com to view compatible dash kits.
7-Inch Screen
• i207-WRA: Jeep Wrangler (2011-2017)
Installation Information:
Q: Why is there engine noise from my vehicle after I installed the Alpine system?
A: Please make sure the head unit has a good chassis ground and the rear seat entertainment retention harness is also grounded. Please contact
us for further assistance.
Q: Why am I not getting any sound from the factory satellite radio tuner?
A: Please verify that the iDatalink 3.5-mm cable is plugged into the iDatalink port on the rear of the unit.
Q: Does the X110-SLV/SRA retain the parking assist function if my truck has the Bose factory system?
A: The parking assist feature is not compatible with trucks with the Bose system. Please contact us for an alternative solution.
iDatalink Maestro Module Set-Up:
Q: I can’t add my Alpine Restyle In-Dash System’s serial number to the online iDatalink system set-up?
A: When you enter the serial number on the iDatalink set-up form, do not add the alphabetical letter at the end of the serial number. If the serial
number is still not accepted, please contact us at the number above and we can help you.
Q: Where on the radio does the 4-PIN iDatalink plug connect to?
A: This plug connects to the “IDATALINK I/F” plug in the reverse camera input harness.
Q: When I try to program the iDatalink Maestro module, I see a red light that flashes twice. What does this mean?
A: Please make sure the 4-PIN iDatalink plug is connected to the “IDATALINK I/F” plug in the reverse camera input harness. Please contact us if you
need further assistance.