Owner's Manual
Table Of Contents
- Installation Manual
- Introduction
- Note
- To Ensure Safe Use, Always Follow These Precautions
- Tools Required
- Accessory List
- Factory Unit Disassembly Process
- Installation Instructions
- Component Locations
- Connection Of An External Amplifier
- Connecting A SiriusXM Module (Sold Separately)
- Connection Of Optional Front Camera
- Connection Of Optional Front Camera
- i407-WRA-JL Wire Descriptions
- i407-WRA-JL HDMI Usage With An iPhone
- i407-WRA-JL HDMI Usage With An Android Phone
- Wire Harness Pin Outs
- Steering Wheel Configuration
- Set Up Guide
- Retained Features
- Troubleshooting Guide
- Owner's Manual
- Operating Instructions
- PRECAUTIONS
- WARNING
- Getting Started
- Setup
- General Setup
- Connection (Bluetooth) Setup
- Camera Setup
- Sound Setup
- Apple CarPlay (Optional)
- Android Auto (Optional)
- Radio/HD Radio™/RBDS
- Radio Basic Operation
- Listening to the Radio
- Presetting Stations Manually
- Presetting Stations Automatically
- Tuning to Preset Station
- Receiving a Multicast (HD Radio™ Mode only)
- Forced Analog Mode
- Selecting the Receivable Program Type (RBDS FM Radio Mode only)
- Using Ballgame Mode (HD Radio™ Mode only)
- Displaying Radio Text (HD Radio™/RBDS FM Radio mode only)
- About the Feature Logos
- USB Flash drive (Optional)
- USB Audio
- USB Video
- USB Photo
- iPod mode on iPhone (Optional)
- SiriusXM Satellite Radio Operation (Optional)
- HDMI Device (Optional)
- Bluetooth Operation
- Hands-free Phone Control
- Bluetooth Audio
- Auxiliary Device (Optional)
- Camera Operation (Optional)
- iDataLink Operation
- Information
- Installation and Connections
- LIMITED WARRANTY
Jeep Wrangler
i407-WRA-JL 20210330v1
9/22
Installation Instructions
1 Mount the microphone next to the rear view mirror
and run the cable behind the factory panels. Route
as shown on the diagram on page 12.
3 Route vehicle cable in main harness from radio
cavity to glove box and connect it to OBDII
gateway behind the glove box. If the gateway is
fully occupied, unclip 1 connector from it and use
T-harness.
4 At radio cavity, connect the main harness, white FM
adapter, and green SiriusXM antenna, and other
adapters to factory harness and secure them.
2 Run the Bluetooth microphone cable down the A
pillar along the OEM wiring. Route as shown on the
diagram on page 12.