Installation Manual

Jeep Wrangler
i407-WRA-JK 20210811v1
 8/18
1 Plug the OBDII connector on to the OBDII port
below the driver side dash and run the extension to
the radio cavity.
2 Attach the side brackets using the provided 8mm
round head screws.
3 Mount the microphone as illustrated and run the
cable to the radio cavity. You will need to use a T20
Torx to remove the visor. For optimal performance
it should be mounted by the rear-view mirror as
illustrated.
4 Run the USB extension cable to an area you want
to plug in at (typically the glove box or center
console areas), connect the main harness, antenna,
and other adapters to the factory harnesses and
secure them.
5 Mount the i407-WRA-JK head unit using the
factory 7mm screws and return factory panels to
their corresponding place
Installation Instructions