Installation Guide

4-EN

01GB04-US_EN.fm

ALPINE iLX-F411/iLX-F409 M3514702010 (EN)

Depending on the vehicle, it may be necessary to adjust the front-

back position of the Display unit when mounting it.

If front-back position adjustment is necessary, set the slider to the

back position before mounting the display unit to the vehicle.

[Default setting: forward position]

1 Remove 4 flush head screws from the Top and Bottom of

the main unit.

2 Push the slider to the back position (To return the slider

to the forward position, pull it forward).

3 Tightly fix the slider using the 4 screws that were

removed in Step 1.

For safe use, make sure of the following:

• Location is stable and firm.

• Does not interfere with safety equipment.

• Driver’s view and operations are not obstructed.

• Microphone is located where the driver’s voice can be easily

picked up (for example, on the sun visor).

When you speak into the microphone, you should not have to change

your driving posture. This may cause a distraction, taking your

attention away from safely driving your vehicle. Carefully consider

direction and distance while mounting the microphone. Confirm that

the driver’s voice can be easily picked up at the selected location.

Adjust the front-back position of the Display

unit (Optional)

WARNING

MAGNETIC SCREWDRIVER REQUIRED TO

CAREFULLY REMOVE SCREWS.

Flush head screw

Main unit

Slider

Mounting the Microphone

Flush head screw

Microphone

Cable clamp

(sold separately)

01GB00-US.book Page 4 Monday, April 27, 2020 5:11 PM