Owner's Manual
IMPORTANT NOTICE!
PLEASE READ FIRST BEFORE INSTALLING LINK KIT
Congratulations on your purchase from Alpine. Your listening satisfaction is
important to us. In order to ensure proper installation
of
your new enclosure the
following guidelines are being provided. Please read this notice carefully
before installing the link kit or remounting the subwoofer.
1.) When installing your linking kit follow the steps provided in the instruction
manual.
2.)Avoid over tightening screws
-
If
remounting a subwoof er or installing a linking kit start each provided
machine screw thread by hand with the included hex key wrench.
- Once each screw is started use a drill torque setting
of
low to fasten.
3.)Do not use an Impact Driver Drill for hardware Installation.
4.)Ifusing the KTE-l0G, or KTE-12G Grille Kit do not use the supplied wood
screws, instead use the 40mm machine screws pre-installed with the enclosure.
5.
)Each Enclosure is wired to a 2 Ohm Load,
if
enclosures are wired in parallel
check that your amplifier is 1 Ohm Stable.
Failure to follow these guidelines may result in enclosure damage which will
void your warranty.
If
further assistance is necessary, please contact your Alpine authorized dealer.