User Manual

ALPINE MRV-V500 68-29530Z24-A (EN/FR/ES)
7-EN
EN
FR
ES
2. Remove the insulation from the ends of the wire
leads by about 7 – 10 mm (9/32” – 13/32”).
(Fig. 5)
Lead end side of
the product
Twist the tip of
wire leads
7 – 10 mm
(9/32” – 13/32”)
Fig. 5
NOTES:
• If length of the exposed wire is too short, a poor
connection may occur causing operation failure
or sound interruption.
• On the other hand, if the length is too long, an
electrical short-circuit may occur.
3. Tighten the hexagon hole screw with the
hexagon wrench (included) to secure the lead.
(Fig. 6)
Before making this connection, use insulated
shrink tubing to cover any exposed wire
extending beyond the terminal.
Hexagon hole screw
Wire Terminal
Twist the tip of
wire leads
Wire
Fig. 6
NOTES:
• Use only the screws included.
• For safety reasons, connect the battery leads last.
• To prevent disconnection of the leads or
dropping of the unit, do not use the cabling to
carry the unit.
es
ne
ed. See
r
d
ary):
mm
2
) or
3 mm
2
)
Fig. 4
nt while
ine fuse
ve post.
supply
he
for the
t how to
21 mm
2
)
(3 mm
2
)
(3 mm
2
)
(3 mm
2
)
k your