Installation Manual

8 -EN
Accessories
Check accessory parts.
AV Input Connector AV Output Connector Power Connector
RUE-4159H Universal
Remote Control
EPG
EXIT
INFO
RUE-4159H
MONITOR
ENTER
MONITOR
SOURCE
TEXT BACK
MENUTOP.M
DISP
RETURN
REPEAT
AUDIO ANGLESUB.T
DVD
EXT-DVD
DVD-HU
1234
5678
90+10CLR
MUTE
DEVICE
DTV
USB
HDMI2 AUXHDMI1
DVD.CMD PIC.M
CH CH SCAN
SETUP
SHS-N106 Single
Source Fold -Flat
Wireless Headphones
Installation Bracket
X 2
Trim Ring
Screws (for
Installation Bracket)
Screws (for Trim Ring)
X 4 X 5
AAA Batteries
Optional FM
Switching Box
Sold
Separately
Part No.
TMXR2000FMSB
Quick Start
Guide,
Installation
Manual,
Registration
Card
HDMI/USB
Cover Plate
X 6
TMX-R3300HDMI Overhead
Monitor
FM Transmitter
Antenna Wire
Optional
KCU-315UH
HDMI/USB
Extension
Connector
Sold
Separately
Top
interchangeable
cover
Right side
interchangeable
cover
Left side
interchangeable
cover
Rear
interchangeable
cover
X 3X 3X 3X 3
#OLOROF)NTERCHANGEABLECOVERHIGHGLOSSGUNMETALBLACKHIGH
GLOSSBRIGHTGRAYHIGHGLOSSCHAMPAGNEGOLD
Wireless Headphones
Headphone Receivers
1) Battery Cover
2) Volume Control
3) Power Switch
4) Power Indicator LED
Operation
Read carefully to prevent damage to the headphone or
your ears:
7!2.).'"EFORETURNINGONTHEPOWERREMOVEHEADPHONESANDTURN
THEVOLUMEDOWNASLOWASPOSSIBLE
1) Be sure the batteries are properly installed in the
headphones.
2) Turn the headphones volume completely down before
placing it on your ears and turning on the power.
3) Turn on the headphone power and adjust the
headphone volume to a comfortable level (You can
increase the audio source volume if needed).
Adjusting the Volume
Volume can be controlled from the headphone or your own radio
volume function.
1 Turn on POWER on the headphone.
2 Adjust the volume level by turning clockwise for
louder and counter-clockwise for lower on the
headphone.
Battery Installation
1 Press and slide open the battery compartment as
shown in the diagram.
2 Place two AAA batteries into the battery
compartment of the headphone(s), making sure
that the battery polarity is correct.
Note
If ACC or the monitor's power source is turned off, a loud noise
may be produced through the headphones. Be sure to remove the
wireless headphones from your ears before you turn the monitor
off.