Installation Guide

Assembling & Using Your Product

Unpack all components carefully. Please check to ensure all parts have been

removed from the packaging. Some splashing may occur.

Components:



Assembling:

 Connect the vinyl tubing to the water pump from inside the fountain top.

Adjust the flow control to the lowest setting to avoid splashing until the

fountain is completely assembled.

 Feed the LED light strand through the center of the fountain base.

Connect the LED light strand to the transformer.

 Place the fountain top on to the fountain basin.

 Gently pour water into the fountain, being careful not to overflow and

cause splashing. Make sure the water completely submerges the pump

and the water runs clear during operation. Plug the transformer and

pump cord into your local power supply. Make sure that there is no

water around the transformer and always keep the power source in a dry

place.

o NOTE: We recommend that you use distilled water to prevent

scale build-up. The first time you operate the pump it can take

up to 5 minutes for the air to be completely expelled and water

begins to flow properly.

PAGE 1
Assembling & Using Your Product Unpack all components carefully. Please check to ensure all parts have been removed from the packaging. Some splashing may occur. Components:  Assembling:     Connect the vinyl tubing to the water pump from inside the fountain top. Adjust the flow control to the lowest setting to avoid splashing until the fountain is completely assembled. Feed the LED light strand through the center of the fountain base. Connect the LED light strand to the transformer.