Owner's Manual

1 2
Using a T30 Torx, remove the OEM harness
mounting plate as shown below. Use a panel
removing tool to remove the two plugs from the
mounting plate.
Subwoofer Installation
3
4
Secure the connector plugs using cable ties to the
left side of the seat as shown below.
13
Connect both amplifiers Note: Be sure to insert the
corresponding connector into each amplifier.
14
Use an impact gun to mount the amplifier assembly
with the supplied (3) Hex head screws.
Place the passenger seat over the enclosure while
carefully aligning the enclosure in between the seat
rails. Mount using (4) 18mm seat bolts.
Amplifier Installation (continued)
Connect the subwoofer to the main harness.
Jeep Wrangler
UNLIMITED JK • 12/19
+
+ +