Owner's Manual

Press the tweeter into the tweeter bridge grille

adapter. Observe the tab orientation.

Route the tweeter wires through the grille by

removing the wire cover. Ensure the wires do not get

pinched when reinstalling the wire cover.

Rear Sound Bar Speaker Installation 2011 – 2014 Models

Route the wire through the notch on the basket, then

press the grille into place. Ensure the wires do not get

pinched.

Add foam strip on top of wires in channel.

Cut a slit in the center of the polyfill, and pull the

vehicle plug through. then insert the excess polyfill into

the sound bar enclosure. Note: Installation of polyfill

is needed for optimum sound.

Insert Polyfill

Select the (2011-2014) crossover input wires and

connect to the vehicle plug. Connect tweeter

connectors. Secure the crossover.

Note: 2015-2017 input plug is not used.

Do not use

(2015-2017)

2007-2014

Connect the tweeter (-)

to the crossover and

select either:

0db wire

+3db wire

(Increased TW level)

for the tweeter (+) lead

(-)

(+)

TW level

+3db

0db

Jeep Wrangler

UNLIMITED JK • 14/19