Owner's Manual

Jeep Wrangler
UNLIMITED JL  6/11
Installation
1 Connect the power cable to the Positive (+) battery
terminal and route the cable down towards frame
of the vehicle. Note: The Negative (-) terminal
should remain disconnected until the installation
is completed.
3 Route the Positive (+) power cable through the
grommet under the carpet and pull the power cable
from under the vehicle. Note: seal the grommet
with silicone (not included) to prevent water from
entering the cabin.
5 Connect the power cable to the main harness.
2 Route the power cable following the factory harness
along the vehicle’s frame.
4 Mount the subwoofer level remote on the center
console next to the gear shifter and route the cable
to the passenger side seat.
Front of Vehicle
6 Attach the Negative (-) ground terminal to the
factory ground stud below the center console.