Installation Manual

Jeep Wrangler
PSS-24WRA V20211025  13/15
7 Plug in the speaker. Use the supplied replacement
bolts (not the OEM 5mm allen heads) and mount the
speaker in the bar.
Rear Soundbar Speaker Removal & Installation (continued)
Troubleshooting Guide
Symptom Possible Cause Remedy
1 System will not turn on Missing or blown fuse at the
battery
Insert or replace fuse
Radio’s Remote Turn-On wire may
be disconnected.
Verify that Remote Turn-On wire
is connected.
2 Volume is too loud with
aftermarket headunit.
Speaker level out is connected at
the T-Harness.
Ensure that the low level RCA
adapters are used in aftermarket
headunit system (refer to the
corresponding wiring diagram).
Amplifiers gain control has not
been properly adjusted.
Refer to the corresponding
system diagram.
3 Subwoofer sounds very low. Gain level may be down to the
lowest setting.
Adjust level to reccommended
setting (refer to the
corresponding wiring diagram).
Audio Phase may be reversed. Ensure that the PHASE is set to
0˚.
RCA adaptor not installed Plug, Orange, RCA adaptor into
the connector near the PWE-S8
then plug RCA’s into PWE-S8.
4 One of the speakers has no sound. Disconnected pin or loose
connection.
Check all connections to
the speaker, loose pins,
disconnected terminals etc..
5 Airbag light is on Failed to disconnect the battery
while working on the vehicle.
Disconnect the battery and
re-connect after 5 minutes.
If problem is not solved, the
vehicle will have to be taken to
a Jeep dealer.
6 System turns on only on radio
source
Aftermarket Power Antenna wire is
connected to amp
Connect the Remote Turn-On
wire (Blue/White) to the Blue
wire on the amplifier harness.