Owner's Manual

SERVICE CARE
+ IMPORTANT NOTICE
This Amplifier has been type tested and found to
comply with the limits for a Class B computing device in
accordance with the specifications in
Subpart
J of Part
15 of FCC Rules. This equipment generates and uses
radio frequency energy, and it must be
installed
and
used
properly in accordance with the manufacturer's
instructions.
+ For European Customers
Should you have any questions about warranty, please
consult
your store
of purchase.
+ For Customers in other Countries
IMPORTANT NOTICE
Customers who purchase the product with which this
notice is packaged, and who make this purchase
in
countries other than the United States of America and
Canada,
please contact your dealer for information
regarding warranty coverage.
SPECIFICATIONS
NOTE:
SERIAL NUMBER:
INSTALLATION
DATE :
INSTALLATION TECHNICIAN:
PLACE
OF PURCHASE:
+IMPORTANT
Please record the serial number of your unit in the
space provided here and keep it as a permanent
record.
The serial number plate is located on the rear
of the unit.
• For product improvement, specifications and design are subject to change without notice.
ACCESSORIES
• Mounting Bracket.. .. ..... .. .......... .. ............ . . .. ....... .. .. . . . . . . . . . ..... .. .. . . .. . ........ .... ..................................... .. .. ............................... 4
• Bracket Screws...................................... .
.
.. ....... .. .. . . . . . . . . . .. .. . . . .. . . . .. . . . .. ......... .. .. . . . . .. .. .... .. . . . .. . . . ... . . . .. ......... .. . . . .. ...... . ......... ... . 8
• Fuse (15A) . ...... .................. .. .. .. . ........ .. .. .................. ...... .. .. ... .... ....... ................. ...... .. .. ...... . ........ ................. .. . ... . .... .. . .... . .... .. . ....... . .. . 1
• lnpuVPower Wire Harness ... .. .......... .... ........ .. . .. ....................... .. . .. ................................... .. .... ... ....... ...................................... .... ... 1
• Remote Bass Level Knob ........
.. ........................ .. ...... .. ... .. .................................. .. ............ .. ................. . .. . .. .. ............... .. ... .. ............. 1
• Velcro .
.. . .. ................. .. ............ .... .. .............. .. ...................................................... .. .............. .. ... .. .. .. .................................................. 1
INSTALLATION (Fig. 1) & (Fig. 2)
&cAUTION
+ Caution on connection terminals/parts
• Keep electrically conductive objects away from the unit's terminals/parts (power terminals, fuses, speaker input
terminals, RCA connectors, etc.). Doing so prevents a possible short circuit and damage to the unit.
MOUNTING
1. Attach the included mounting brackets to the PWE-S8 with the supplied screws. (See to Fig. 1)
2. Once the brackets are mounted to the PWE-SB. Place the subwoofer in the desired location within the
vehicle. Before securing with screws, check to make sure all screws can affix to a structurally solid surface
while avoiding vehicle wiring, components, etc. (See F
ig. 2)
Note: For securing the mounting brackets to the vehicle,
it may be necessary to use longer screws (not
included) to accommodate carpet thickness, etc.
NOTE:
To sec ur ely co nn ec t the ground lead, use an already installed sc r ew on the metal part of the ve hicl e ( mark ed *). Be s ur e
this is a
go od ground by ch ec king continuity to the battery (-) termina l. As much as po ssible connect all equipme nt to the
sa me ground point. These procedures will help eliminate noise.