Owner's Manual

14
Linkwitz-Riley, Bessel and Butterworth options.
Frequency setting: Adjust low-pass or high-pass
frequency by directly entering the value, scrolling
mouse wheel or pressing up/down arrow keys. Range
of adjustment: 20Hz~20KHz.
Frequency slope (Slop) setting: Drop-down menu
has 8 options: 12dB/Oct, 18dB/Oct, 24dB/Oct, 30dB/
Oct, 36dB/Oct, 42dB/Oct, 48dB/Oct and close.
Set Sound Volume and Phase
Position of Output Channel
1. The editing and display panel for output channel
sound volume, low-pitched phase position, phase EQ,
phase position editing and displaying panel.
In the positive phase position,
a. Channel sound volume: Adjust the channel
volume by directly scrolling the volume fader, or
entering the value or scrolling mouse wheel. The
range of adjustment: Close -59dB ~ 0dB.
b. Mute button: Click [
] to mute the channel
sound volume and click again to cancel the mute
(mute will be automatically canceled when adjusting
the channel sound volume).
c. Click [Positive Phase] to change output phase
position: positive or inverted.
d. Low-pitched phase position and phase EQ:
Adjust the phase by directly entering the value,
scrolling mouse wheel or pressing up/down arrow
keys. The range of low-pitched phase: 0° ~ 360°. The
range of phase position EQ: 20Hz~20KHz.
Low-pitched phase position could set 20Hz-200Hz
frequency bands adjustable at 0-360°, with a
resolution of 2°. Phase position EQ could rotate 180°
of nearby frequency point’s signal phase position.
Select Type of Output Channel
1. Select output signal channel types.
types. Such as pre-three-modulus crossover and
post-dual-crossover; 5.1 System; 7.1 System etc.
a. Click [Reset]: Clear or restore default output
setting.
b. Click [Combined Tuning] to tune the left and
right channel. You need to select the method for
data synchronization before combined tuning.
c. Click [EQ] or [Sound Source Mixing] to enter
the tuning interface.
Set Delay
1. Output signal delay panel.
a. Delay: Adjust by directly entering the value,
scrolling mouse wheel or pressing up/down arrow
keys.
b. Delay unit: Drop-down menu, the default unit
of delay is [Millisecond] and either [cm] or [inch] is
also available for selection.
In the inverted phase position
Software for PC