User Guide

11-EN
Basic
Adjusting the built-in Crossover
You can change High Pass Filter, Low Pass Filter,
Phase on this unit, so that you can create your
favourite sound effects.
1 Press the X-OVER button repeatedly to select
the desired parameter.
2 Press the DN g or f UP button to select
the disired setting.
1. HPF (Setting the High Pass Filter):
→ OFF ←→ 80Hz ←→ 120Hz ←→ 160Hz ←
Outputs all frequencies higher than that selected
according to your preference.
2. LPF (Setting the Low Pass Filter):
→ OFF ←→ 80Hz ←→ 120Hz ←→ 160Hz ←
Outputs all frequencies lower than that selected
according to your preference.
(Only available when using the subwoofer output
from this unit.)
NOTES
• If you turn the battery power OFF, all settings return
to factory default.
• If HPF, LPF, Bass Control and Treble Control are all
set to ON, depending on the Bass Control and Treble
Control settings, you may not be able to reinforce the
sound effect.
• Except when the HPF and LPF is turned OFF, the
subwoofer is in monaural mode.
• When the subwoofer is set to OFF, LPF mode and
change of phase does not work.
• If no buttons are pressed within 5 seconds, the display
for setup menu disappears while an ordinary menu
appears on the display.
→ OFF → HPF →LPF
Changing the Audio Level Display
Pattern
You can select the disired display pattern mode
from three Audio Level Display Patterns. You can
also deactivate the display.
1 Press DISP button to switch the display pattern.
→ Pattern 1 → Pattern 2 → Pattern 3 → Display OFF