Owner`s manual

16-EN
InCaseofDifculty
If you encounter a problem, please turn the power off, then on again.
If the unit is still not functioning normally, please review the items in
the following checklist. This guide will help you isolate the problem
if the unit is at fault. Otherwise, make sure the rest of your system is
properly connected or consult your authorized Alpine dealer.
No function or display.
• Vehicle's ignition is off.
- If connected following the instructions, the unit will not
operate with the vehicles ignition off.
• Improper power lead connections.
- Check power lead connections.
• No fuse or blown fuse.
- Replace the fuse on the battery lead of the unit with the
proper value.
• Vehicle’s battery is weak.
- Check the voltage of vehicle’s battery.
Unit does not operate.
• Monitor's power is not turned on.
- Turn on the monitor's power.
• Condensation
- Wait a while (about 1 hour) for the condensation to dry.
No picture is produced.
• Monitor's mode is not switched to the mode you want to see.
- Switch to the mode you want to see.
• Monitor's parking brake cord is not connected.
- Connect the monitor's parking brake cord and set the parking
brake. (For details, refer to the monitor's instructions.)
• Monitor's parking brake is not set.
- Connect the monitor's parking brake cord and set the parking
brake. (For details, refer to the monitor's instructions.)
Picture is unclear or noisy.
• Vehicle's battery power is weak.
- Check the battery power and wiring.
(The unit may malfunction if the battery power is under 11
volts with a load applied.)
No picture display.
• Brightness control is set for minimum brightness control.
- Adjust the brightness.
• Incorrect setting of the mode.
- Switch to the correct mode.
- Check the connection to the source unit.
- Check the power of the source unit.
• Incorrect or open connection with the Monitor, AV interface
unit.
- Check the connection and remedy.
Picture color is poor.
• Brightness/Color/Tint/Contrast/Sharpness control are not set
to the proper positions.
- Check each control.
Spots or dotted lines/stripes appear.
• Caused by neon signs, high-voltage power lines, CB
transmitter, other vehicle’s ignition plugs, etc.
- Change the location of your vehicle.
Due to continuous product improvement, specications and
design are subject to change without notice.
Package Contents
1x TMX-310U USB/SD Multimedia Overhead Monitor System
1x AV Connector Cable and Power Harness
1x AV Connector Cable
1x USB Extension Cable
1x IR Remote Control
6x Self-Tapping Screws
4x M4 (14mm) Metal Screws
4x Screw Holder
4x Screw Hole Cover
1x Mounting Bracket
Installation of Bracket
Specications
Video Display System NTSC/PAL compatible
Screen size (Diagonal) 10.2”
Screen resolution 800 RGB (H) x 480 (V)
Signal system NTSC / PAL
Brightness 300 nit
Contrast ratio 250
Viewing angle (U/D, L/R) 45/65, 65/65
Video input level (typical) 1 Vp-p/75Ω
Audio input level (typical) 500 mVrms/47KΩ
Carrier frequency for IR sensor NEC_R code / 38 KHz
Operating voltage (direct current) 10.8~15.6V
Current consumption (typical) 1.5A
Operating temperature -10° C to +60° C
Storage temperature -30° C to +85° C
Dimensions (w x h x d) 312 x 270 x 47 mm
Weight 1.7 kg (unit only)
Supports multiple partitions per storage device formatted in
either FAT32 or NTFS.
*Installation Bracket is used to stabilize the monitor at the time
of installing the monitor. Ask ALPINE dealer for detail.
x 4