Installation Manual

Toyota
FULL SIZE TRUCK  9/14
Installation Instructions
1 Connect the Maestro Module to the main harness.
2 Using a cutting tool, trim the marked gray area.
(This will allow for the X009 to sit high enough on
the dash)
3 Connect the main harness to the factory harness
and secure it.
4 Remove the center top dash cover using a panel
removal tool. Place GPS antenna as illustrated and
feed the cable down to the X009.
5 Mount the microphone using the included clip and
run the cable to the radio cavity.
6 Plug the OBDII connector cable into the OBDII
port below the driver side dash and run the
extension to the headunit cavity.