User Manual

      User Guide Information for UGPZ6-C3 v2.0

June 2, 2008

page2

2.1 USA

2.1.1 Compliance statement to FCC

This module complies with part 15 of the FCC rules. Operation is subject to the following conditions: (1)

This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

2. 1. 2 RF exposure compliance

This module may be installed into any end product in mobile device applications.

For Mobile Configuration, this module complies with FCC radiation exposure limits set forth for uncontrolled

equipment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65.

It is desirable that it should be installed and operated with at least 20cm and more between the radiator and

person’s body (excluding extremities: hands, wrists, feet and legs). 

The module installer shall obtain FCC approval for the end product, if the module is used for Portable

application.



2.1.3 Requirements to end product

The following provisions for end product will be required on the FCC regulation, part 15.

(1) Antenna

We wishes that module installer shall use the UGPZ6-C3 module without any modifications including antenna.

If module installer uses a unique antenna, the FCC certification is required for the end product.

(2) Co-location.

This UGPZ6-C3 module must not be co-located or operated in conjunction with any other antenna or

transmitter.

(3) Markings

To satisfy FCC exterior labeling requirements, the following text must be placed on the exterior of the

end product.

Any similar wording that expresses the same meaning may be used.

(4) Caution to user for modification

The following caution is expressed on the user’s instruction manual.

(5) Compliance statement to FCC

The following statement is expressed on the user’s instruction manual.

2.2 Canada

In general, I.C (Industry Canada) follows the FCC in terms of emission levels and other regulatory

requirements.

2.2.1 Compliance statement for IC

This device complies with Industry Canada RSS-210. Operation is subject to the following conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

The changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the device.

This module complies with part 15 of the FCC rules. Operation is subject to the

following conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation.

Contains Transmitter Module FCC ID: CWTUGPZ6-C3