User's Manual
The connector is arran
g
ed as shown in the fi
g
ure belo
w
■CAUTION■
Operating temperatur
e
range
-40~＋85 degree C
MAX 1.0mA(@12.5V 2
5
℃) at standb
y
Weight
Please DO NOT the following. Engine is not started by failure of electronic
parts. (Product can not receive the signal correctly)
Pay attention to the following.
(The operation range might be changed by the environment. )
・Do not contact and bring metals close to the engine SW and the key.
・It may not be operated when using the equipment of the same
frequency band in the vicinity.
0.049kg
Consumption curren
t
s
p
e
c
MAX 200mA(@12.5V 2
5
℃) at operatio
n
User's Manual
It communicates with IC used both as Transponder and Passive RKE
through LF ANT(Z axis) of I-key H/U, and operates as ANT to exchange
communication data depending on community signal with BCM.
The immobilizer antenna communicates with the transponder in the hand unit
when the hand unit is brought close, and receives the code of the key. The
immobilizer is used by bringing the hand unit close as shown in figure.
Product name : Immobilizer base station
Type : TWK1A026
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Size
・Give a shock.
・Get it wet. If it got wet, wipe and dry up.
・Disassembly and modification
.
This device complies with Part 15 of FCC Rules and Industry Canada licence-
exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of
this device.
Operation of frequency 125kHz
DC6V～16V
A
C/DC Suppl
y
Operating voltag
e
DC6～16V(Inner:DC 5V
)
DC12V
Range of voltag
e
Consumption curren
t
Under 1.0m
A
（Standby curren
t
）
W40.2xL70xH40.2（mm）
HUND UNIT
Immobilizer base station
CONNECTORPINLAYOUT
NAME