Installation Instructions
Table Of Contents
- Wireless specifications
- Pin out diagram
- Mechanical layout
- Recommended footprint layout
- Yanzi stamp radio module images
- Electrical specifications
- Power supply recommendation
- Operating and storage requirements
- Antenna specifications
- 2.4 GHz chip antenna S-parameters and radiation patterns
- Layout and general design recommendations
- Host Product verification and testing
- Certification and compliance information
Date: 2022-06-13 Doc No:890-07082-Yanzi-stamp-user-manual
Copyright © 2022 Altacogni AB. All rights reserved. Yanzi is a brand of Altacogni AB
Altacogni AB,
C/O nordomatic, Arenavägen
27, Johanneshov, Sweden
Info@altacogni.com
www.yanzinetworks.com
Doc rev No: 1.1
Model: VAI1-0004, Rev: R1B
Page: 17
Industry Canada statement
• IC ID: 20363-VAI10004
• This device contains license-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s license-exempt RSS(s).
Operation is subject to the following two conditions:
1) This device may not cause interference.
2) This device must accept any interference, including interference that may cause
undesired operation of the device.
• L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes:
1) L’appareil ne doit pas produire de brouillage;
2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
CE
• Yanzi stamp complies with the Essential Requirements of RED (Radio Equipment
Directive) of the European Union (2014/53/EU). Yanzi stamp meets the ETSI 300 328
V2.2.2 and ETS 300 220 V3.2.1 conformance standards for radio performance.
Compliance marking for FCC and Industry Canada
• Yanzi stamp modules are FCC and IC certified radio modules that carries a
“Modular” grant. Yanzi stamp radio modules comply with the “Intentional Radiator”
portion (Part 15c) for FCC certification.
• The host product, incorporating a Yanzi stamp module will require additional
compliance testing to any other FCC rules that may apply to the host not covered by
the modular transmitter grant certification.
• For other local compliance regulations (CE, UL etc.) the host product manufacturer is
responsible to ensue all required compliance testing is completed.
• The integrator is responsible for the final compliance of the end product including this
certified transmitter module.