User's Manual

C1_Configuration_Manual_-_fm_1.0.0.1.doc

Commercially Confidential

For CE configuration, the max. Transmit Power is limited to 10dBm

4.11.2 Wireless Mode and Radio Frequency

Altai C1 Super WiFi CPE can offer 2.4GHz radio access, the following tables list the operation

mode and available frequency under the particularly wireless mode. Default setting of AP mode

radio is working on 2.4GHz 54Mbps (802.11b/g) and default channel is channel 6 (2437MHz).

2.4GHz Radio Mode Data Rate Channels Radio Frequency

802.11b 11 Mbps 1,2,3,4,5,6,7,8,9,10,11 2.412GHz-2.462GHz

802.11b/g 54 Mbps 1,2,3,4,5,6,7,8,9,10,11 2.412GHz-2.462GHz

802.11g 54 Mbps 1,2,3,4,5,6,7,8,9,10,11 2.432GHz-2.462GHz

Table 2 2.4GHz Radio Frenquency

NOTE: In CE configuration, Ch 1 -13 is supported.

4.11.3 Service Set IDentifier (SSID) and Virtual Access Point (VAP)

In order for the C1 CPE and mobile clients to communicate, they must all be configured to use

the same SSID for communication both at the VAP and clients ends. SSID broadcast can be

enabled or disabled by selecting Suppress SSID. Suppress SSID is used to prevent unauthorized

users scanning for SSID while still allowing users who know the correct SSID to connect.

VLAN can be enabled by adding different VLAN Tag ID. The traffic will pass through the

specific VLAN switch port when VLAN is enabled.

Each VAP setting (including SSID) can be altered by selecting Edit. The setting of each VAP is

shown in Figure 19. The default SSID for each VAP ID is Altai Wireless Network. VLAN Tag

can also be set here.