User's Manual

TPS09-005_rev1 0_A3_Configuration_Manual_-_fm_1 0 0 6 _FCC.doc
Commercially Confidential
3
Radio Frequency Interference Requirements
This device complies with Part 15 of FCC Rules.
Operation is subject to the following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
3. This device should not be co-located or operating in conjunction with any other antenna
or transmitter.
Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, (example – use only shielded interface cables
when connecting to computer or peripheral devices). Any changes or modifications not
expressly approved by the party responsible for compliance could void the user’s authority to
operate this equipment.
Warning
The user is advised to keep apart from the base-station and antenna with at least 45cm when the
base-station is in operation.
Disclaimer
All specifications are subject to change without prior notice. Altai Technologies assumes no
responsibilities for any inaccuracies in this document or for any obligation to update information
in this document. This document is provided for information purposes only. Altai Technologies
reserves the right to change, modify, transfer, or otherwise revise this publication without notice.