User's Manual

Altai A8n (ac) Series Super WiFi Base Station

Installation Guide

Mounting A8-Ein (ac) on Pole

1. Assemble the mounting kit according to Figure 4 with one side of

the screw installed.

2. Mount the kit to the pole at the desired height and tighten all 4

screws to fix its position (Figure 5).

3. The mounting kit must be installed with the key hole pointing

down (Figure 6).

4. Clamp the A8-Ein (ac) unit to the mounting kit, as shown in Figure

7 and make sure the mounting screw is locked in the key hole.

5. Screw in 4 locking screw to secure A8-Ein (ac) with the mounting

kit (Figure 8).

6. Adjust A8-Ein (ac) tilting by relaxing the pair of tilting screws and

tighten them back when the angle is fixed (Figure 9).

7. The mounting kit will fit with pole diameter from 1 inch to 3

inches.

Figure 4. Mounting kit assembly Figure 5. Mounting kit assembly

Figure 6. Key hole direction